Stratasys F270 - Page 17

8
Figure 2-2: Welcome Kit Contents - Tools
Table 2-2: Key for Figure 2-2
1
Leather
Safety
Gloves
Printer components may be extremely hot. To prevent burns or other injuries, these gloves should
be worn any time you see the gloves safety sign throughout this document. See “Product Safety
Signs” on page 2.
2 Needle
Nose Pliers
(extra slim)
Occasionally, you may need to use pliers to aid in the clearing of debris which have accumulated
on the head and/or tips (see “Clean/Inspect Tip Wipe Assemblies” on page 165).
3 Needle
Nose Pliers
(7
1
/
8
)
Occasionally, you may need to use pliers to aid in the clearing of debris which have accumulated
on the head and/or tips (see “Clean/Inspect Tip Wipe Assemblies” on page 165).
4 5” Cutters These are used to cut a material spool’s filament when unloading and removing materials from the
printer. See “Unloading Material” on page 113.
5 Loupe
Magnifier
This tool is included to aid you with performing a Manual Tip Calibration which requires you to view
small toolpath relationships. See “Manual Tip Calibration” on page 144.
6 Scraper This tool is used to scrape parts or material off the substrate.
1
2
3
4
5
6