Stratasys F270 - Page 218

209
End of model filament detected
• Indicates that filament from the material spool has not been detected by the filament present switch
in the material drive.
• Correct condition - slowly turn the material spool and feed filament into the drive mechanism.
Filament needs to be advanced approximately 2 inches (50.8 mm) to reach the filament present
switch. See “Loading Material” on page 108 for instructions.
End of support filament detected
• Indicates that filament from the material spool has not been detected by the filament present switch
in the material drive.
• Correct condition - slowly turn the material spool and feed filament into the drive mechanism.
Filament needs to be advanced approximately 2 inches (50.8 mm) to reach the filament present
switch. See “Loading Material” on page 108 for instructions.
Cooler module not installed
• Indicates that the bead cooler has not been installed with the associated PLA material head.
• Correct condition - install the bead cooler.