211
Cannot load support in to model head
• Indicates that you have installed a support spool into the wrong location within the material bay.
• Correct condition - Remove the support spool from its current location within the material bay and
insert it into a support material bay. For printers with two operating material bays, the support bay is
the right bay. For printers with four operating material bays, the support bays are the two right-most
bays. See Figure 3-11 on page 29 for details.
Cannot change material type during build
• Indicates that the printer is currently in the process of building and you are attempting to change
model or support material during the build.
• Correct condition - you cannot change material types while the printer is in the process of building a
part. Wait until the build is complete before changing materials.
To Next Page
Loading...
