88
To configure this setting, press anywhere within the row; the Wifi page will be displayed. Use the radio buttons
within the page to turn the setting On and Off as needed; On is selected by default.
Figure 4-56: Configure Wifi
CAMERA
The Camera setting gives you control over the printer’s camera. When this setting is set to On, the printer’s
camera will automatically provide remote monitoring capabilities while a part is being built. When this setting is
set to Off, the camera will be turned off and remote monitoring capabilities will be disabled.
Figure 4-57: Camera
To configure this setting, press anywhere within the row; the Camera page will be displayed. Use the radio
buttons within the page to turn the setting On and Off as needed; On is selected by default.
Figure 4-58: Configure Camera
To Next Page
Loading...
