Stratasys Objet24 - Stratasys Printing Software Overview

Using Objet Studio
5–10 DOC-34014 Rev. C
3. IntheFilesoftypefield,selectthefiletypetodisplay.
4. Selectthedesiredfile,andmakesurethatitappearsintheFilename
field.
IfthePreviewcheckboxisselected,theobjectisdisplayedinthedialog
box,asshowninfigure 5‐9.
TheModelSettingsribbonis
displayedwhenobjectsareplacedonthe
buildtray.
5. Selectanyofthefollowingoptions,asrequired:
• Units—Millimetersorinchesfortheobject’sunitsofmeasure.
The3Dfilecontainstheobjectʹsproportions,butnotitsunitsof
measure.Therefore,makesuretocorrectlyselecteithermillimeters
or
incheswheninsertinganobject.Otherwise,thesizeoftheobject
onthebuildtraywillbeeithermuchtoolargeormuchtoosmall.To
changethemeasurementunitsofobjectsalreadyplacedonthetray,
see“MeasurementUnits” onpage 26.
• Number of copies—Howmanycopiesofthisobjecttoplaceonthe
buildtray.
• Orient Automatically—Automaticallyorientobjectsonthebuildtray
forefficientmodelbuilding.
Note: The Extents values displayed in the Coordinates section of the Insert
dialog box, represent the maximum dimensions of the object on each
axis. These dimensions correspond to the virtual “bounding box”
surrounding the object see figure 5-21 on page 33).