SummaCut cutter User’s Manual
WARNING: The SummaCut cutters use razor-sharp knives. Touching the
knife with bare hands may cause injury. Do not touch the knives while the
machine is cutting.
The entire base plate should be considered as a dangerous area when the cutter is
switched on and off. The tool carriage can move from the left to the right and the
yellow media sleeves are sharp and can grab loose objects, clothing or body parts.
The cutter constantly measures the current through the motors. If the machine detects
the current is too high, then the current will be cut off to the motors and a fatal error
message will be displayed on the control panel.
Make sure to observe all the caution labels on the cutter.
Environmental conditions can significantly affect the machine’s performance.
The environmental conditions of the machine (without media) are as follows:
35 - 75 %, non-condensing
35 - 75 %, non-condensing
It is possible that the environmental conditions of the used media are stricter than
those of the machine itself. Please refer to the documentation about the used media.
Moreover, make sure that the media has had enough time to acclimatize.
NOTE: Keep the cutter away from direct sunlight or a strong indoor light
source. The optical sensors in the machine may be affected, thus causing
unexpected behaviour of the cutter.
WARNING: There is a risk of injury from being caught or trapped in moving
machine parts.
Keep hands, hair, clothing and jewellery away from moving parts. Do not
wear jewellery, loose clothing, scarves, open jackets or shirtsleeves.
To Next Page
Loading...
