Summa D120 - Changing the Tool Pressure

SummaCut cutter User’s Manual
Basic Operation 2-4
2.2.2
Changing the tool pressure
1.
Power on the cutter, load media, and mount the tool (see section 1).
2.
Press .
‘Knife pressure’ will appear on the LCD.
3.
Press .
Current pressure will appear on the LCD.
4.
Press or to change the knife pressure.
The value will change
1. Press to perform the internal knife pressure test (see section 1.7.1).
2. Press to confirm the chosen knife pressure.
3. Press to leave the pressure unchanged.