Summa D120 - Copy User; Factory Def; FW Version; IP Config

SummaCut cutter User’s Manual
Detailed Operation 4-9
4.3.4.1
IP config
A couple of parameters need to be set when connecting a cutter to the Ethernet. This
can be done is this menu. This is explained in section 1.5.2.
4.3.4.2
Language
This submenu is used to set or modify the dialogue language on the touch screen.
When the machine is new, it asks the user to choose a language. If this setting was set
to the wrong language, it can be changed with this option.
The information on the touchscreen can be displayed in English, French, German,
Spanish, Italian, Polish or Dutch.
Press , then use or to set to the desired language. Press to confirm
or to cancel.
The default language is chosen when the cutter is switched on for the first time.
4.3.4.3
Menu Units
The setting of these options determines whether the speed and size values are
displayed in the metric measure system or in the ENG/US measure system.
Press , then use or to set to the desired measure system. Press to
confirm or to cancel.
The panel units are chosen when the cutter is switched on for the first time.
4.3.4.4
FW version
Press the button to view information about the cutter’s firmware revision. This
information is often helpful to technicians when diagnosing problems over the
telephone.
4.3.4.5
Copy User
This option copies all the settings of User 1 to the other 3 (user 2 to 4) by default.
4.3.4.6
OPOS Parameters
The setting of extra parameters has already been explained in previous sections.
Sheet mode
These settings are explained in section 3.4.3.
OPOS Panelling
These settings are explained in section 3.3.6
OPOS Origin
These settings are explained in section 3.4.1
4.3.4.7
Factory Def.
This option defaults all user parameters to factory default.