Summa D120 - Cutting Multiple Copies of a Graphic on the same Roll; Cutting the same Graphic on Multiple Media Sheets

SummaCut cutter User’s Manual
Contour Cutting 3-12
3.4.2
Cutting multiple copies of a graphic on the same roll
If the same graphic design has been printed on a roll with equal distance between
these different graphics, then this feature can be used.
This way of automating is very software dependable. Usually the necessary parameters
need to be set in the software itself. In rare cases, the distance between jobs needs to
be set in the cutter itself. The only possible way to do this is to use Summa Cutter
Control.
3.4.3
Cutting the same graphic on multiple media sheets
This feature can be used if the same graphic design has been printed on multiple
sheets.
ATTENTION: The sheets should approximately the same size and the
graphics on them should be oriented and positioned the same way.
First, load the media and check whether the parameters of the OPOS marks are set
correctly.
Cutting the same graphic on multiple media sheets:
1.
Power on the cutter.
2.
Press .
‘Knife Pressure’ will appear on the LCD.
3.
Press .
‘System Setup’ will appear on the LCD.
4.
Press .
‘Actions’ will appear on the LCD.
5.
Use or to scroll through the menu until ‘Configuration’ is reached, press
.
6.
‘IP Config’ will appear on the LCD.
7.
Use or to scroll through the menu until ‘OPOS Parameters’ is reached,
press .
‘Sheet Mode’ will appear on the LCD.