Summa D120 - Extended Load; Replot; Reset; Media Alignment

SummaCut cutter User’s Manual
Detailed Operation 4-4
4.3.1.4
Extended Load
This parameter is explained in section 1.
4.3.1.5
Replot
The RECUT instruction recuts the last file, which was sent to the cutter (provided it
fitted into the buffer). Press the key to execute the instruction.
4.3.1.6
Reset
The RESET instruction performs a complete reset of the cutter. Press the key to
execute a reset.
4.3.1.7
Media alignment
Align load is a special loading procedure to register marks, so that pre-printed jobs can
be contour-cut. The parameter is explained in section 3.3.5.