Summa D120 - Setting Cutting Speed

SummaCut cutter User’s Manual
Basic Operation 2-6
How to Set the Cutting Speed
2.3
The actual speed at which the tool moves is determined by 4 different parameters.
Speed (and acceleration) while the tool is down; speed (and acceleration) while the tool
is up. These 4 parameters have been bundled in one parameter to enable to change
the speed fast and easy.
This overall parameter is called “velocity” and represents the speed the cutter uses
when the tool is down. If velocity is raised or lowered, the other parameters are also
raised or lowered accordingly. The parameters can be changed individually but only
with the program Summa Cutter Control.
There is one fixed speed: the speed at which the cutter pulls the media from the roll.
This speed is fixed at 200 mm/s (8ips).
Setting the cutting speed:
1.
Power on the cutter.
2.
Press .
‘Knife pressure’ will appear on the LCD.
3.
Press .
‘’System Setup’ will appear on the LCD.
4.
Press .
’Actions’ will appear on the LCD.
5.
Press .
’ Settings’ will appear on the LCD.
6.
Press .
’Velocity’ will appear on the LCD.
7.
Press .
’Current set velocity will appear on the LCD.
8.
Press or to change the velocity.
The velocity will change on the LCD.
9.
Press to confirm.
An asterisk will appear before the velocity, indicating it is now the selected velocity.
10.
Press twice to leave the menu.