Summa D120 - Software and Connectivity

SummaCut cutter User’s Manual
Specifications 6-2
6.2.4
Software
• WinPlot
• “Bridge” program to cut artwork created in other programs.
• Windows 7, 8 and 10.
• Connection by USB, serial, parallel or any printer port installed on operating
system.
• Connection by IP address.
• Import of simple AI, EPS and DXF files.
• Plug-in for CorelDraw 12 -> X7, for Adobe Illustrator CS -> CC.
• Nesting, panelling, weeding box and cut by colour possibilities.
• Integration of OPOS.
• MacSign Cut
• “Bridge” program to cut artwork created in other programs.
• Mac OS 9 & Mac OSX (10.2 or higher).
• Import artworks from Illustrator, Freehand, Canvas, CorelDraw,…
• Connection by USB.
• Resizing positioning, mirroring, …
• Registration required.
• Summa Cutter Control
• Program to control cutter parameters.
• Utility to upgrade firmware.
• Possibility to store user configurations on hard disk.
• Windows 7, 8 and 10.
• OPOS Barcode Server.
6.2.5
Cutter accessories and consumables delivered with cutter
The following accessories and consumables are available for your SummaCut cutter:
Manual and driver CD User’s
English, German, French, Spanish, Italian
and Dutch
MD9045 Included
Power Supply Cables
region dependent
1x
Serial Cable
423-183
-
USB Cable
399-111
1x
Standard knife (set of 5x)
391-360
2 knives
Standard knife holder
391-332
1x
Sandblast knife (set of 5x)
391-358
-
Sandblast knife holder
391-363
-
Fibre tip pen (black) (set of 4)
MP06BK
1 pen
Rollerball pen (set of 4 :Red, Green,
Blue, Yellow)
MP0646 -
Flanges for roll media (set of 2)
391-510
1 set
Manual cut-off razor
blades (set of 10)
391-146 1 extra blade
Razor blade & holder
391-290
1x
Pouncing kit
391-595
-
Floor Stand D60(SE)
399-050
-
Floor Stand with Basket D60(SE)
399-075
-
TABLE 1:
ACCESSORIES AND CONSUMABLES