SummaCut cutter User’s Manual
Detailed Operation 4-10
4.3.4.8
USB class can be set to Summa USB port 1, Printer Uni (unidirectional), Printer Bidi
(bidirectional), Summa USB port 2, Summa USB port 3, or Summa USB port 4.
Printer Uni and Printer Bidi are for use with printer adaptors with either network or
wireless connection.
Because of the different USB id’s, the computer can make a distinction between
several cutters attached to it (maximum 4).
Press . Use or to change the USB Class. Press to confirm or
to cancel. The default USB class mode is Summa USB port 1 (called standard on older
machines - only this setting is compatible with older USB drivers).
ATTENTION: The minimum USB driver version required for attaching more
than 1 cutter to the same computer is 6.2.
The change in USB class only
becomes active after rebooting the cutter.
ATTENTION: The USB id in the cutting software needs to be the same as the
chosen USB id in the cutter
. Each time a new USB is selected on the cutter
and connected for the first time to the computer, the wizard will be started by
Windows in order to install a driver.
ATTENTION: Cutters with firmware revisions lower than 19 do not have the
possibility to assign an id to a USB port, so only one cutter can be connected
to one computer via the USB.
The Autoload option enables the user to the change the vinyl unroll procedure. When
autoload is activated, the cutter will automatically unroll the vinyl, when needed. When
the autoload option is deactivated, the operator should manually unroll enough media
before starting to cut. When autoload is set to ask, the cutter will pause as soon as the
pinch rollers are put down. This gives the user the time to lower pinch roller pressure, if
necessary.
The default setting is ON. Tracking is not guaranteed when autoload is set to OFF.
Press , then use or to activate or deactivate the autoload feature. Press
to confirm or to cancel.
Autoload is activated by default.
Tracking is not guaranteed when autoload is set to OFF.
The
submenu is used to set or modify the distances between the jobs
when making multiple recuts.
Press , then use or to change the baud rate. Press to confirm or
to cancel. The default value is 40 mm.
To Next Page
Loading...
