SummaCut cutter User’s Manual
Contour Cutting 3-11
OPOS origin is set to ‘Current Position’
Upon receiving an OPOS job from the computer, the cutter will immediately start
searching for the OPOS XY line by slowly moving forward the media. Once it has found
it, it will follow this line to the right until it finds the location of the first mark and then
start searching for the actual first mark. Therefore, the user will need to set the origin
under the OPOS XY line, immediately after having loaded the media.
This setting has been created for jobs, which are left aligned and differ a lot in size. The
origin/tool can then be set to the left of the media under the OPOS XY line, so that the
origin mark can be found, even if it is situated far away from the right side of the media.
OPOS origin is set to ‘Centre of media’
Upon receiving an OPOS job from the computer, the cutter first sets the OPOS sensor
in the middle of the media. Then it will start searching for the OPOS XY line by slowly
moving forward the media. Once it has found the XY line, it will follow it to the right
until it finds the location of the first mark and then it will start searching for the actual
first mark.
This setting has been created for jobs on a roll where the width of each job is at least
half the width of the media (this is usually the case; otherwise there would be a lot of
wasted media). This method is slightly slower than the previous method.
To Next Page
Loading...
