SummaCut cutter User’s Manual
Use static address:
The static address that you received will be used in the software to drive the cutter. It
has also to be set in the cutter itself.
It is recommended to use an static IP address.
1. Connect the Ethernet cable and power on the cutter (see section 1.4.3).
2. Press .
‘Knife Pressure’ will appear on the LCD.
3. Press .
‘System Setup’ will appear on the LCD.
4. Press .
‘Actions’ will appear on the LCD.
5. Use or to scroll through the menu until ‘Configuration’ is reached, press
.
‘IP Config’ will appear on the LCD.
6. Press .
‘DHCP’ will appear on the LCD.
NOTE: The default setting for the cutter is DHCP. If the setting has already
been changed to “STATIC” then leave it at that, otherwise change it to this
value as described below.
7. Press .
‘An IP address is shown on the screen.
8. Press . Press until the blinking cursor is above the first digit. Then use
or to set the correct value. Press the to jump to the next digit. Repeat
this until the IP address is set correctly.
9. Then press to jump to the subnet setting. Repeat the above procedure to set
the subnet correct.
10. Then press to leave the menu and reboot the cutter.
To Next Page
Loading...
