Summa D120 - Page 62

SummaCut cutter User’s Manual
Contour Cutting 3-16
The value will change on the LCD.
6.
Press to confirm.
An asterisk will appear before the value, indicating it is now the selected setting.
ATTENTION: It is difficult to give recommended settings for FlexCut. Check
section 3.5.2.2.
7.
can be pressed at any time during the settings of the parameters to check the
result.
The cutter will cut out a pattern to check if the settings are usable.
8.
Check if the result is satisfactory. If not, change one of the above parameters.
Reducing the velocity can also improve the result.
NOTE: FlexCut parameters are always metric, regardless the value of the
menu Units parameter (see section on 0)
ATTENTION: When cutting through, it is recommended that parallel lines are
at least 1 cm (0.4”)
away from each other. Otherwise, while cutting the second
line, the first line may come loose and cause trouble.
9.
Press to confirm.
10.
Press to leave the FlexCut menu.
‘FlexCut’ will appear on the LCD.
11.
Use or to scroll through the menu until ‘System setup’ is reached, press
.
‘Actions’ will appear on the LCD.
12.
Use or to scroll through the menu until ‘Settings’ is reached, press .
‘’Velocity’ will appear on the LCD.
13.
Use or to scroll through the menu until ‘Panels’ is reached, press .
‘ON’ or ‘OFF’ will appear on the LCD, depending on whether panelling is already
activated or not.
14.
Press or to choose the Panel parameter panel size (unit of that value will
be in cm).