Summa D120 - Page 8

SummaCut cutter User’s Manual
Table of contents IV
5
Maintenance and Cleaning ................................................................................... 5-1
Introduction ..................................................................................................................... 5-1
5.1
5.1.1 Cleaning the drive system ........................................................................................... 5-1
5.1.2 Cleaning the media sensor ........................................................................................ 5-2
5.1.3 Cleaning the Y-Guide Rail .......................................................................................... 5-2
5.1.4 Changing the fuse ........................................................................................................ 5-3
6
Specs and General Information ........................................................................... 6-1
Models .............................................................................................................................. 6-1
6.1
Features List .................................................................................................................... 6-1
6.2
6.2.1 Hardware ......................................................................................................................... 6-1
6.2.2 Interface ........................................................................................................................... 6-1
6.2.3 Functionality .................................................................................................................... 6-1
6.2.4 Software .......................................................................................................................... 6-2
6.2.5 Cutter accessories and consumables delivered with cutter ............................. 6-2
Technical Specification ................................................................................................ 6-3
6.3
6.3.1 Machine dimensions .................................................................................................... 6-3
6.3.2 Shipping dimensions ................................................................................................... 6-3
6.3.3 Media ............................................................................................................................... 6-4
6.3.4 Performance ................................................................................................................... 6-6
6.3.5 Interface .......................................................................................................................... 6-6
6.3.6 Firmware ......................................................................................................................... 6-6
6.3.7 Environmental ................................................................................................................ 6-7
6.3.8 Electrical .......................................................................................................................... 6-7
6.3.9 Certifications .................................................................................................................. 6-8
Cutter accessories and consumables part numbers ............................................. 6-9
6.4