S CLASS™ cutter User’s Manual
Contour Cutting 3-18
6. Press or to choose FlexCut mode (accurate is recommended) and
press to confirm.
The FlexCut menu will appear on screen.
7. Press .
The menu to change the full (cut through) pressure will appear on screen.
8. Press or to change the pressure (180 gr is a recommended starting
value) and press to confirm.
The FlexCut menu will appear on screen.
9. Press .
The menu to change the cutting length at full pressure will appear on screen.
10. Press or to change the cut length (10mm is a recommended starting
value) and press to confirm.
The FlexCut menu will appear on screen.
11. Press .
The menu to change the flex (bridge) pressure will appear on screen.
12. Press or to change the pressure (80 gr is a recommended starting
value) and press to confirm.
The FlexCut menu will appear on screen.
13. Press .
The menu to change the cutting length at flex pressure will appear on screen.
14. Press or to change the cut length (0.8mm is a recommended starting
value) and press to confirm.
The cutter will cut out a test pattern.
To Next Page
Loading...
