Sun Microsystems SUN BLADE 150 - Page 8

viii Sun Blade 150 Service Manual • June 2002
10.2 OpenBoot Emergency Procedures for Systems With USB Keyboards 10–2
10.2.1 Stop-A Functionality 10–2
10.2.2 Stop-N Equivalent Functionality 10–2
10.2.3 Stop-F Functionality 10–3
10.2.4 Stop-D Functionality 10–4
A. Product Specifications and Reference Information A–1
A.1 Physical Specifications A–1
A.2 Electrical Specifications A–2
A.3 Acoustic Specifications A–2
A.4 Environmental Requirements A–3
A.4.1 Clearance Requirements for Proper Cooling A–3
A.5 Reference Information A–4
A.5.1 IDE Cabling Configuration A–4
A.5.2 CD-ROM and DVD-ROM Jumper Settings A–5
A.5.3 CD Handling and Use A–5
A.5.3.1 Inserting a CD Into the CD-ROM or DVD-ROM Drive
A–5
A.5.3.2 Ejecting a CD From the CD-ROM or DVD-ROM Drive
A–6
A.5.3.3 Cleaning the CD-ROM or DVD-ROM Drive A–6
A.5.3.4 Handling and Storing CDs A–6
A.6 Modem Setup Specifications A–6
A.6.1 Setting Up the Modem A–7
A.6.2 Changing the Serial Port Speed A–8
A.6.3 Modem Recommendations A–9
A.6.3.1 Cable A–9
A.6.3.2 Modem Switch Settings (AT Commands) A–9
B. Signal Descriptions B–1