Symmetricom TimeSource 3100 User Guide

Chapter 4 TL1 Reference
Commands
114 TimeSource User’s Guide 097-72020-01 Revision K – December 2005
Aid Parameter Value Description
TS3100 ROFREQ=a a=5 or 10 Frequency for both remote oscillator inputs
in MHz
TOD=a a=CISCO Serial TOD message sent in CISCO format
a=NTP4 Serial TOD message sent in NTP4 format
a=NONE No serial message sent
ALMCOND=a a=ALW Alarm conditioning for E1, TOD, and IRIG-B
outputs is enabled
a=INH Alarm conditioning for E1, TOD, and IRIG-B,
outputs is disabled
IPNE=a.b.c.d
(See Note 1)
a = 0 to 255 IP address of this TimeSource 3100
(command must be sent from COM1,
COM2, or Craft port to set this parameter)b = 0 to 255
c = 0 to 255
d = 0 to 255
IPSUBNET=a.b.c.d
(See Note 1)
a = 0 to 255 Subnet mask for this TimeSource 3100
(command must be sent from COM1,
COM2, or Craft port to set this parameter)b = 0 to 255
c = 0 to 255
d = 0 to 255
IPGATE=a.b.c.d
(See Note 1)
a = 0 to 255 Default gateway IP address for this
TimeSource 3100 (command must be sent
from COM1, COM2, or Craft port to set this
parameter)
b = 0 to 255
c = 0 to 255
d = 0 to 255

Symmetricom TimeSource 3100 Specifications

General

Brand	Symmetricom
Model	TimeSource 3100
Category	GPS
Language	English