Chapter 4 TL1 Reference
Commands
140 TimeSource User’s Guide 097-72020-01 Revision K – December 2005
E1-a FRAMING=b b=CAS Output framing is CAS
b=CAS4 Output framing is CAS4
b=CCS Output framing is CCS
b=CCS4 Output framing is CCS4
b=NONE Output framing is NONE (if an analog
signal). (If ALMOUT is SQUELCH, the
signal will turn off during holdover alarm.
No other ALMOUT option affects output
during alarm.)
ALMOUT=b b = AIS Output during holdover alarm is AIS
b = SQUELCH No output during holdover alarm
b = SSM Output is “SSUT” quality level message
during holdover alarm (SSM requires
output framing of CAS4 or CCS4)
OPT-a
(Additional
eight E1
outputs for
990-72020-
02 systems
only)
ALMOUT=b b = AIS Output during holdover alarm is AIS
b = SQUELCH No output during holdover alarm
b = SSM Outputs is “SSUT” quality level message
during holdover alarm (SSM requires
CAS4 or CCS4 output framing)
FRAMING=b b = CAS Output framing is CAS
b = CAS4 Output framing is CAS4
b = CCS Output framing is CCS
b = CCS4 Output framing is CCS4
b = NONE Output framing is NONE (if an analog
signal) (If ALMOUT is SQUELCH, the
signal turns off during holdover alarm. No
other ALMOUT option affects output
during alarm.)
To Next Page
Loading...
Need help?
General
