T-VIPS CP560 - PLP Configuration

To Next Page

To Previous Page

126 WEB Interface

CP560 DVB-T2 Gateway User’s Manual Rev. 2.2 (3686) ID: um_t2gateway

Note: Leap seconds are entered in UTC+00 time format. To get the

actual time of day this will be added for your local time you need to

subtract your time zone.

Leap Second Status

Status ﬁeld for the leap second handling. Will state the number of days, hours, minutes

and seconds until the conﬁgured leap second will be added.

Note: An notiﬁcation will be given when the leap seconds is added. This

notiﬁcation can be seen in the alarm log, see section 8.3.2.

8.6.4.3 PLP conﬁguration

The PLP conﬁguration page has all the PLP conﬁguration parameters. The list on the left hand

side shows the current number of PLPs in the system. It is possible to have from 1 up to the

licenced number of PLPs.

Figure 8.71 PLP Conﬁg

PLPs Common Conﬁg lists conﬁguration parameters that apply to all the PLPs.

Override Capacity validation

This option lets you have less cell occupancy than 50% in a T2-Frame. This is not a valid

signal, and is only intended for PLP Replacement systems.