WEB Interface 85
ID: um_t2gateway CP560 DVB-T2 Gateway User’s Manual Rev. 2.2 (3686)
transmit the file from the administrator PC to the device. Once the file has been transferred,
it is verified using and internal checksum value and set as the new active firmware image.
If the upload is successful the progress bar turns green and the unit reboots itself loading
the new image, unless the Reboot on success option has been unchecked.
If the upload is unsuccessful the progress bar turns red and an error message is displayed
in the Status field.
Cancel
The Cancel button is enabled during the upload process and can be clicked to cancel the
operation. It is not possible to continue a cancelled upload.
Reboot on success
This checkbox is checked by default but can be unchecked to disable automatic reboot
upon SW loading completion. If this option is not checked the SW will load but will not
be activated before the user performs a manual reboot. Note that this option is not stored
on the device, and Reboot on success will be enabled next time you enter the SW upgrade
page.
During SW loading, an alarm SW loading in progress is set with the Details field displaying the
IP address of the machine from which the loading was initiated. The alarm is turned off when
the loading is completed or terminated.
If the Reboot on success option is active the unit will automatically reboot when loading is
complete, otherwise an alarm New SW pending is set to indicate that a new SW will be used
on next manual reboot.
After uploading, if the Progress bar shows OK but the web interface does not change to the
Waiting for reset state, allow some time for the device to reset itself and then reload the web
UI via the web browser reload button.
Note: It is recommended to verify the new software version via the “Prod-
uct Info” page (Section 8.4.1) to verify that the update was successful
and the latest software revision is active.
8.4.8.3 Feature Upgrade
The Feature Upgrade sub-page provides an interface to upload new software licences to upgrade
the feature set of the device. The licence key is provided as a text file. Paste the content of file
into the text area and click the Load Key button. The device needs to be restarted to activate
the new features.
Reset can be performed from the GUI as explained on the Maintenance > General tab in Section
8.4.8.1.
Note: The entire content of the licence key text file must be copied into
the text box, not just a portion of the file.
To Next Page
Loading...