72 WEB Interface
CP560 DVB-T2 Gateway User’s Manual Rev. 2.2 (3686) ID: um_t2gateway
Required level for read
The required user level for TXP read accesses. This may only be edited if Mode is different
from Disabled and Anonymous read is not selected.
Required level for write
The required user level for TXP write accesses. This may only be edited if Mode is set to
Write.
Below follows a simple example of how to get the units uptime. A description of the TXP
protocol can be found on the T-VIPS Product CD, or by contacting T-VIPS Support.
http://10.0.0.10/txp_get?path=/dev/time|_select:uptimetxt
<response request_id="0" method="txp_get" time_stamp="2012-08-17 11:14:20" version="1.0">
<status status="0" status_text="OK"/>
<data>
<dev>
<time uptimetxt="49 days 21h:56m:09s"/>
</dev>
</data>
</response>
8.4.5.4 SNMP Settings
The Simple Network Management Protocol (SNMP) is used to monitor network-attached devices
for conditions that warrant administrative attention. This page gives access to SNMP settings
such as destination IP addresses of trap receivers and community string. It Also displays a log
of the latest traps sent by the unit.
Figure 8.27 SNMP Settings
The Trap Destination table lets the user configure the trap servers that should receive SNMP
traps from the unit. To add a server click the Add new button, enter an IP address, then click
To Next Page
Loading...