T-VIPS CP560 - 6.1.4 ASI output ports; 6.1.5 1 PPS Input; 6.1.6 Ethernet Data Ports

To Next Page

To Previous Page

Physical Description 31

ID: um_t2gateway CP560 DVB-T2 Gateway User’s Manual Rev. 2.2 (3686)

Table 6.2 Port direction options on 2

ASI card variant

ASI port Input Output Copy Output

1 X X -

2 X X -

3 X X -

4 X X -

5 X X -

6 X X -

7 - X -

8 - - X

Table 6.4 ASI Input LED description

LED Colour Description

Upper yellow Lit when input is enabled, unlit otherwise.

Lower green Lit when input is in sync, unlit if not in sync.

6.1.4 ASI output ports

The CP560 can transmit 1 T2-MI ASI stream. The rightmost connector is used as the principle

ASI output. Some of the other ports can be conﬁgured as copies of the principle output as

shown in chapter 6.1.2.

One LED is used for each ASI output port: A green LED is lit whenever the output is enabled.

6.1.5 1 PPS Input

The CP560 comes with a 1 PPS input. Activating the port is a software option that enables the

device to operate as a MIP inserter in SFN networks.

The 1 PPS port is mounted to the right, below the output ports.

1 PPS input

BNC female 50 ohms

6.1.6 Ethernet Data Ports

The CP560 comes with two Ethernet data ports. These data ports can be used to carry MPEG

transports streams if the licence key Ethernet data interface is installed.

These ports can also be used for management of the device.