144 SNMP
CP560 DVB-T2 Gateway User’s Manual Rev. 2.2 (3686) ID: um_t2gateway
VIGW-UNIT-MIB
This is a generic MIB module that defines parameters supported by all products. It is the
main source for alarm and status related information. The following objects are examples
of contents in this MIB:
• Top level alarm status
• Table of current alarms
• History of last transmitted TRAP messages
• Trap destination list
• Force reset of the unit
• TRAP/NOTIFICATION definitions
• Other, general product information:
− Serial number
− SW version
Note: When setting values in the unitAddressTable it is important to send
all values for one interface in the same request. This is to prevent the unit
from entering an undefined intermediate state.
VIGW-PLAT-TS-MIB
This MIB contains Transport Stream related information for each of the transport stream
inputs. It is supported by transport stream related products that are able to analyse in-
coming transport streams. For each input transport stream, the following information is
available:
• Transport stream sync status and total/effective bitrate.
• Present PIDs with information about bit rates and CC errors.
• Present services with information about service name and service ID.
VIGW-PLAT-TSOUT-MIB
This MIB is supported by products that can generate an outgoing transport stream. Para-
meters include:
• Control of output bitrate and other ASI parameters (spread/burst mode).
• Control of MIP insertion (if enabled in the product)
− OFDM modulation parameters
− Enable/disable of MIP insertion
• Control of PSI/SI/PSIP table playout
To Next Page
Loading...