TB30s SIP Administrator Guide v1.3 Page 57 of 259
1. In the order:
Remote loading of file INF
Remote loading of the firmware
Reboot
2
nd
Remote loading of file INF
Remote loading of the file TelConf
Remote loading of the file Common_config
Attempt of remote loading of the specific file MAC if he is
Reboot
Remote loading of file INF
2
nd
Attempt of remote loading of the specific file MAC if he is
(Remote loading of the files Deck for MGCP)
2. The phone is connected to the service of the operator.
Some precise details:
If phone doesn‟t receive an IP address, you need to check up that the parameter ModeDHCP is
activated
The file “Common_config” will be downloaded only if the file‟s name has been change
compared to the last upgrade.
The specific file MAC is downloaded (if there exists) if his parameter “config_sg” was
incremented.
It is imperatively necessary to download the file TelConf before returning it to the customer.
It is possible to pass from a phone SIP and quite simply to transform it into MGCP (but not the
reverse) by providing on phone SIP a firmware corresponding to MGCP protocol as well as the
good files which go with.
To Next Page
Loading...
Need help?
General