Installation
1-12
TDS5000 Series User Manual
Other software products may be compatible but have not been tested by
Tektronix. If the oscilloscope malfunctions after you install software, uninstall
the software and then reinstall the oscilloscope application to restore proper
operation.
Exiting the Oscilloscope Application. Before installing other desktop applications,
exit the oscilloscope application. To do this, select the File menu E xit command.
Some TDS5000 options and upgrades contain software that needs to be installed
and/or enabled. Follow the specific instructions that come with the option.
Tektronix provides a key that you must enter (one time) to enable all options or
upgrades that you have purchased. To enter the key, select the Option Installation
command from the Utility menu of the oscilloscope application, and follow the
on-screen instructions.
Connecting to a Network
You can connect the oscilloscope to a network to enable printing, file sharing,
internet access, and other communications functions. Before you make the
connection, do the following steps to enable network access to the oscilloscope:
1. Begin with the oscilloscope power off.
2. Attach a keyboard and mouse to the oscilloscope.
3. Power on the oscilloscope.
4. As the oscilloscope begins to boot, press the keyboard F2 key repeatedly
until the message “Loading SETUP” appears.
5. In the BIOS Setup Utility, use the keyboard right-arrow key to highlight the
Advanced menu at the top of the screen.
6. Use the arrow down key to highlight Peripheral Configuration in the
Advanced screen, and then press Enter.
7. Use the arrow down key to highlight LAN Device in the Peripheral
Configuration screen, and then press Enter.
8. Use the arrow up or down key to highlight Enabled, and then press Enter.
9. Press the F10 key to save and exit. Confirm the Save of Configuration
changes when you are prompted on screen.
TDS5000 Options and
Upgrades
To Next Page
Loading...
Need help?
General
