Appendix A: Specifications
A-2
TDS5000 Series User Manual
Separate Digitizers. Ensure accurate timing measurements with separate digitizers
for each channel. The digitizers can also be combined to yield a higher sample
rate on a single channel.
Fast Acquisition. Acquire up to 100,000 waveforms per second to see rapidly
changing signals or intermittent signal irregularities.
Long Record Lengths. Choose record lengths from 500 points to up to 100,000
points per channel (up to 400,000 points on a single channel). Extend the
maximum record length up to a maximum of 8,000,000 points with memory
options.
Peak Detect Acquisition Mode. See pulses as narrow as 400 ps, even at the slower
time base settings. Peak detect helps you see noise and glitches in your signal.
Acquisition Cont rol. Acquire continuously or set up to capture single shot
acquisitions. Enable or disable optional acquisition features such as equivalent
time or roll mode.
Horizontal Delay. Use delay when you want to acquire a signal at a significant
time interval after the trigger point. Toggle delay on and off to quickly compare
the signal at two different points in time.
Average, Envelope, and Hi Res Acquisition. Use Average acquisition mode to
remove uncorrelated noise from your signal. Use Envelope to capture and
display the maximum variation of the signal. Use Hi Res to increase vertical
resolution for lower bandwidth signals.
Waveform Math. Set up simple math waveforms using the basic arithmetic
functions including FFT, or create more advanced math waveforms using the
optional math expression editor. Waveform expressions can even contain
measurement results and other math waveforms.
Spectral Analysis. (Optional) Display spectral magnitude and phase waveforms
based on your time-domain acquisitions. Control the oscilloscope using the
traditional spectrum analyzer controls such as span and center frequency.
Acquisition Features
Signal Processing
Features
To Next Page
Loading...
Need help?
General
