Installation
TDS5000 Series User Manual
1-13
10. Use the Windows network setup utility to define the oscilloscope as a
network client, and configure it for your network. You can find the network
setup utility in the Windows Start menu if you select Settings > Control
Panel and then double click Network. You should consult your network
administrator for specific instructions to make these settings.
NOTE. If you want to disable network access for the oscilloscope, perform the
above procedure, except substitute Disabled for the command listed in step 8.
The oscilloscope will boot faster with network access disabled.
Setting up a Dual Display
Dual display lets you view Windows and other applications on an external
monitor while running the oscilloscope. You can also drag up to five dockable
control windows from the TekScope application onto the display of the second
monitor. For example, this feature allows you to have the Horizontal/Acquisi-
tion, the Horizontal Zoom, and the Display Setup C ontrol Windows (half screen)
open on the second monitor at the same time.
If your instrument is using Windows ME, use the following steps to set up the
oscilloscope for dual display operation:
1. Disconnect the oscilloscope power cord from the power source so that you
can connect an external monitor.
2. Connect a keyboard and mouse to the oscilloscope.
Windows ME
To Next Page
Loading...
Need help?
General
