ATG7 module adjustment procedures
6. Locate variabl
e resistor R927 on the ATG7 circuit board. (See Figure 5-1.)
7. Adjust R927 to match the level of the first chroma packet to the preceding
75% flat bar.
8. Change the BNC cable connection from the SIGNAL connector to the BARS
connector o
ntheATG7module.
9. Locate variable resistor R977 on the ATG7 circuit board. (See Figure 5-1.)
10. Adjust R977 to match the first chroma packet to the level of the preceding
75% flat bar.
5–8 TG8000 Multiformat Test Signal Generator Service Manual
To Next Page
Loading...
