9D-11
Figure 9D-5. Upper Front Mounting Bracket
9. Remove the tank from the frame.
10.Remove the filler cap from the hydraulic tank.
INSTALLATION
1. Install the filler cap on the hydraulic tank.
2. Place the hydraulic tank on the frame. Secure the
hydraulic tank with two mounting bolts through the
rear mounting bracket and two mounting bolts
through the upper front mounting bracket.
3. Remove the plugs from the outlet hose and return
hoses. Using the tags created during removal,
connect the hoses to the hydraulic tank.
4. Replace the hydraulic oil filter (Figure 9D-6).
Figure 9D-6. Hydraulic Oil Filter
5. Pivot the seat and seat platform to the lower posi-
tion for normal operation. Latch into position.
6. Install the negative battery cable on the battery.
7. Make sure the drain plug is in the tank and fill the
hydraulic tank with hydraulic oil. The 628 Turfcat is
supplied with Jacobsen 10W30 hydraulic fluid.
GreensCare 68 hydraulic oil can be used for bio-
degradable oil applications.
8. Start the engine and check the component opera-
tion.
Upper Front
Mounting Bracket
Mounting Bolts
To Next Page
Loading...
