9D-10
REMOVAL
1. Using a portable filtering unit, pump the hydraulic
oil into a suitable clean container. The tank holds
6.8 U.S. gallons (25.7 liters). If a filtering unit is not
available, remove the drain plug at the bottom of
the tank and drain the oil into a suitable container
(Figure 9D-3).
Figure 9D-3. Drain Plug Location
2. After draining, replace the hydraulic tank drain
plug.
3. Unlatch the seat platform (Figure 9C-3).
4. Pivot the seat and seat platform to the full upward
position (Figure 9C-3).
5. Disconnect the negative battery cable from the
battery.
6. Tag and disconnect the hydraulic return hoses and
outlet hose (Figure 9D-3). Immediately plug the
hoses and tank to prevent contamination of the
hydraulic system.
7. Remove two mounting bolts from the rear mount-
ing bracket of the hydraulic tank (Figure 9D-4).
Figure 9D-4. Rear Mounting Bracket
8. Remove two mounting bolts from the upper front
mounting bracket (Figure 9D-5).
NOTICE
If available, use a portable filtering unit when drain-
ing the hydraulic oil. If a portable filter is not avail-
able, the oil should be drained into a clean container
and filtered for use. If filtering is not available, dis-
pose of the hydraulic oil and fill the tank with clean fil-
tered oil.
NOTICE
Dispose of unwanted oil properly. Dumping oil in an
unsafe manner is illegal. Check with local environ-
mental officials for information on properly disposing
of oil products.
Hydraulic
Tank
Filler Cap
Breather/Vent
Hose
Connections
Drain Plug
NOTICE
The seat and seat platform must be pivoted upward
to allow access to the hydraulic hoses.
Rear Mounting Bracket Mounting Bolts
To Next Page
Loading...
