Preventive Maintenance Guidelines
128 Administrator Guide v 2.2 Thermo Scientific Smart-Vue
®
Wireless Monitoring Solution
22.1.4.2 Alarm Conditions
Shown on LCD
In case of a sensor alarm, the LCD on the Smart-Vue module displays
information concerning the detected alarm.
Figure 72. Smart-Vue module indicating high alarm condition
CAUTION: It is important to note that for alarms triggered when a limit
value has been exceeded, the triangular indicator remains displayed on the
Smart-Vue module screen until the alarm is acknowledged by a user in
Smart-Vue Client. The triangle remains displayed even if the sensor value
returns to a level within normal operating limits.
22.1.4.2.1 Displayed warnings The module displays a specific message for each alarm that is detected.
These messages appear on the bottom line of the LCD.
For single modules:
HIGH VALUE
A reading is above the high limit value (after time
delay, if configured).
LOW VALUE
A reading is below the low limit value (after time
delay, if configured).
SENSOR FAIL
The sensor is not working, or no sensor was
detected.
For dual-sensor modules:
HIGH VALUE 1
A reading is above the high limit value (after time
delay, if configured) on the first sensor.
LOW VALUE 1
A reading is below the low limit value (after time
delay, if configured) on the first sensor.
SENSOR 1 FAIL
The first sensor is not working or was not
detected.
HIGH VALUE 2
A reading is above the high limit value (after time
delay, if configured) on the second sensor.
LOW VALUE 2
A reading is below the low limit value (after time
delay, if configured) on the second sensor.
SENSOR 2 FAIL
The second sensor is not working or was not
detected.
For all modules:
LOW BATT
Indicates that battery power is equal to or below a
value of (10%).
STOPPED
Indicates that the module is currently not logging
data.
To Next Page
Loading...
