< 1 >
MODIFICATION HISTORY
EAA-02466 KEY OPERATION SPECIFICATION
Date
Modified
Pages
Description
Sept. 19, 2008 – Newly published.
May 11, 2009 3 The period of time of holding down the POWER key was identified.
5, 42, 202 • The statues during communication were deleted from the LED lightening
patterns in Sections 5.3, 6.3 and 6.9. The LED indication in a low battery
state was modified.
• Buzzer volume controllability was mentioned.
8 • Regarding the startup LCD display, explanation of g Version
information/MAIN program version was added. Accordingly, the number
for the head width was changed (from g to h).
• IPL startup was deleted from Section 5.7 LCD Display at Startup.
16, 17, 210,
211
Post-print stop position setting, back feed restriction setting and strip issue
back feed setting were added to the Mode Setting Operation Example in
5.13.1 and 6.12.2.1 and the Mode Setting Items in 5.13.2 and 6.12.2.2.
31 Wireless LAN power save setting was added to <WLAN> in 5.18.3 Interface
Setting Items.
35 The LED status for the LOW BATTERY error was corrected in 5.20.
36, 38 to 40 The Ir PACKET ERROR indication was added in 5.20 and 5.23.
50, 51 In (1) of 6.6.1.2 Self-test Items, Post-print stop position setting, back feed
restriction setting and strip issue back feed setting were added to d Various
parameter values, and wireless LAN power save was added to WLAN
SETTING.
53 to 55 PAPER STOP, BF.RESTRICT, PEEL BF. and POWER SAVE were added to
the print sample in 6.6.1.2 Self-test Items. The label length was changed in
the note for the print sample for maintenance counter/parameter values and
automatic self-test. “Example” was added to (1) Automatic self-test print.
57 The count condition was changed (from 69.4 cm to 50.0 cm) for Total label
distance covered/Label distance covered of the maintenance counter in
6.6.1.3 Self-test Result Items.
59, 60, 63,
63
Values for the writable character/BASIC file/PC save/form/graphic areas in (2)
Various parameter values table in 6.6.1.3 were corrected.
Post-print stop position setting, back feed restriction setting and strip issue
back feed setting were added. Wireless LAN power save was added to
WLAN SETTING.
As NOTE 2, an explanation for the size depending on installed DBCS was
added.
59, 71 AUTO2 was added to head division setting for the 2-inch head in 6.6.1.2 and
6.6.2.2.2.
68, 69 Post-print stop position setting, back feed restriction setting, strip issue back
feed setting were added to 6.6.2.1 Mode Setting Operation Example.
73, 74 A commentary was added to 6.6.2.2.4 Linerless Setting.
76 to 78 Post-print stop position setting, back feed restriction setting and strip issue
back feed setting were added to 6.6.2.2.6, 6.6.2.2.7 and 6.6.2.2.8,
respectively.
108 Supplemental explanations (5) and (6) were added to 6.6.4.2.6 Strip Position
Fine Adjustment.
The comment “up to V1.0C” was added to explain the case where no print
position fine adjustment value was set.
To Next Page
Loading...
Need help?
General