Toshiba B-EP Series - Page 55

- 46 -
(2) Print head check for broken dots
Power OFF
(1) Power off state
(2) While holding down the [FEED] key, press the
[POWER] key to turn the power on.
[FEED] [POWER]
< 0 > S H U T D O W N
(3) System mode menu display (Shutdown)
[PAUSE]
(4) Press the [PAUSE] key.
< 1 > D I A G N O S T I C
(5) System mode menu display (Self-test)
[POWER]
(6) Press the [POWER] key.
M A I N T E N A N C E C O N T
(7) Print mode for maintenance counter values
and various parameter values
[PAUSE]
(8) Press the [PAUSE] key.
A U T O D I A G N O S T I C
(9) Automatic self-test mode
[PAUSE]
(10) Press the [PAUSE] key.
H E A D C H E C K
(11) Print head check for broken dots mode
[POWER]
(12) Press the [POWER] key.
C H E C K I N G
(13) Start of print head check for broken dots
[When a broken dots error is not found]
N O R M A L E N D
(14) The result is displayed. (Normal end)
[PAUSE]
(15) Press the [PAUSE] key.
< 1 > D I A G N O S T I C
(16) System mode menu display (Self-test)
[When a broken
dot error is found]
H E A D E R R O R
(14’) The result is displayed. (broken dots error)
An error mark icon turns on and the red LED
blinks.
[PAUSE]
(15’) Press the [PAUSE] key.
< 1 > D I A G N O S T I C
(16’) System mode menu display (Self-test)