Safety instructions
6 11/2020 243343V03_EN
1.5.4 General safety instructions
The general safety instructions are listed below:
Any modifications to the machine that could impair its safety must be
reported by the operator immediately.
Never touch the edge of the knife.
In the case of malfunctions, always disconnect the main power supply
first and secure it against unintended reconnection.
The machine must not be operated if damaged, e.g. defective safety
devices, cover or lid, switches or buttons.
Always wear the personal protective equipment when working in the
open cutting chamber and when cleaning the knife.
Handle the cleaning agent carefully. Follow the manufacturer's direc-
tions for use of the cleaning agent and protective equipment.
In the event of a fire or explosion in the machine, the main power supply
must be disconnected and secured against unintended reconnection.
Before starting any maintenance and repair work on the machine, the
main power supply must be disconnected and secured against unin-
tended reconnection.
Only spare parts or accessories that are supplied or expressly ap-
proved by TREIF may be fixed to the machine or replaced. Any liability
and warranty on the part of TREIF Maschinenbau GmbH is excluded
for any damage caused by the use of non-GENUINE TREIF SPARE
PARTS and accessories.
Unauthorised conversions and modifications to the machine that can
impair its safety are prohibited.
Ensure that all lids, covers and doors for maintenance and operating
work are always opened as far as they will go. Risk of crushing hand
and fingers from automatic closure.
If the knife is running despite any open lid, cover or door, the machine
must be switched off immediately.
Danger!
Failure to observe the following safety instructions presents a
risk of danger to life, physical injuries or substantial material
damage.
In the case of malfunctions, the machine must generally not be
put back into operation until the cause of the fault has been
cleared by an authorised person (TREIF service personnel if
necessary).