Cleaning the discharge conveyor during running operation
26 11/2020 243343V03_EN
3.4 Cleaning the discharge conveyor during running operation
When changing to another product, the discharge conveyor must be
cleaned.
b Put the machine in the cleaning position
(☞ „Cleaning mode“ on page 19).
b Remove the protective cover of the discharge conveyor.
b Open the knife box door.
b Clean the discharge conveyor in accordance with the instructions in the
cleaning schedule.
When cleaning is finished:
b Switch off the cleaning mode.
b Install the protective cover of the discharge conveyor.
b Start the machine.
Risk of injury!
Crushing hazard and danger of being pulled in by moving belts.
To Next Page
Loading...