EC Declaration of Conformity
For the purpose of the EC Machinery Directive 2006/42/EC, Annex II No. 1 A.
Machinery category:
Dicing machine
Machine designation:
TWISTER basic
Series / part number:
412012.240412.-
We hereby declare that the design of the above mentioned machine in the supplied version
complies with the applicable provisions of the EC Machinery Directive 2006/42/EC.
The machine also complies with the following Directives / Regulations:
EU EMC Directive 2014/ 30/EU
EC Regulation for Food Contact Materials 1935/2004/EC
EU Plastic Regulation for Food Contact Materials 10/2011/EU
The protection objectives of the Low Voltage Directive 2014/35/EU have been complied with
in accordance with Annex I, No. 1.5.1 of the Machinery Directive 2006/42/EC.
The following harmonised standards have been applied:
DIN EN 13871: 2015-01: Food processing machinery –
Cubes cutting machinery –
Safety and hygiene requirements
The normative references in the European standard mentioned above are also applicable, such as:
DIN EN ISO 12100: 2013-08: Safety of machinery –
General principles for design –
Risk assessment and risk reduction
DIN EN ISO 13849-1: 2016-06: Safety of machinery –
Safety-related parts of control systems –
General principles for design
DIN EN ISO 13857: 2008-06: Safety of machinery –
Safety distance to prevent hazard zones being reached by
upper and lower limbs
DIN EN 60204-1: 2010-05:
[IEC 60204-1: 2005, modified]
Safety of machinery –
Electrical equipment of machines –
General requirements
The dicing machine is exclusively intended for cutting boneless foods such as meat, sau-
sage, cheese and potatoes. Any other use of the machine is prohibited.
Refer to the operating instructions for detailed information about the specification and the
ambient conditions.
This declaration shall be rendered invalid if any modification without our agreement is made
to the machine.
The following person is authorised to compile the technical
documentation:
Jörg Fankhänel
Toni-Reifenhäuser-Str. 1
57641 Oberlahr
TREIF Maschinenbau GmbH
Toni-Reifenhäuser-Str. 1
D – 57641 Oberlahr
Oberlahr, 01. Februar 2019
[Uwe Reifenhäuser – Managing Director]
Translation of the original d
To Next Page
Loading...