usi M9000 - Figure 3-16 Manage Line Groups Page

92
Figure 3-16 Manage Line Groups Page
• Line Group Name
This drop-down list displays the Line Groups automatically initiated by the wizard tool. Selecting a
group from this list will display the channels assigned to the group.
• Fault Location Details
These following fields are disabled at this step in the wizard tool. They will be enabled for entries
when the wizard steps to the Fault Location page (see Section 3.1.6).
o Auto Calculate Fault Location:
o Positive Resistance (Ohm):
o Positive Reactance (Ohm):
o Zero Resistance (Ohm):
o Zero Reactance (Ohm):
• Channels List
This field displays the analog channels assigned to the selected group. The convention used to
describe each channel is: Chassis ID, Channel #, Description, and Phase.
• Button
This button displays the edit line group tool below. This is used to revise the Channels List for
groups initiated by the wizard.