Vaisala AWS310-SITE - Page 143

Command Syntax Description
ftp <getputtest>
<source_file>
[destination_file]
[‑if interface]
[‑user username]
[‑pass password]
[‑rst restart_at] [‑active]
[‑opt options]
Transfers files to or from the QML data logger or tests the connection to
the FTP server:
• source_file defines the name of the source file on the QML data
logger or the FTP server.
• destination_file
defines the name of the destination file.
• ‑if interface defines the name of the interface to use for the FTP
connection.
• ‑user username and ‑pass password
define the username and
password for the FTP server.
ftp put source_file ‑user username ‑pass password uploads
a file from the QML data logger to the FTP server.
ftp get source_file ‑user username ‑pass password
downloads a file to the QML data logger.
ftp test destination_file ‑user username ‑pass password
tests the connection to the FTP server.
help [command] help lists all the available commands.
help command displays the command syntax.
http <get|post> <URI>
[‑src source_file]
[‑type content_type]
[‑dst destination_file]
[‑size max_size]
[‑if interface] [‑dbg Y|N]
Retrieves information from the server or posts information on it.
• URI defines the HTTP URI to read from or write to (for example, a
file).
• ‑src source_file defines the source filename.
• ‑type content_type defines the content type of the message (see
www.iana.org/assignments/media-types/media-types.xhtml).
• ‑dst destination_file
defines the destination filename.
• ‑size max_size defines the maximum size of the returned content.
• ‑if interface defines the network interface (for example, eth0).
• ‑dbg Y|N defines whether or not to send debugging information to
the debugging port.
ifpriority <setdefault|
setprimary|setsecondary>
[interface]
Displays and modifies the priority order of network interfaces.
ipconfig
Shows the IP configuration of all open network interfaces. The command
has no parameters.
LASTVAL <component> <ID> [F]
[S]
Shows the measured value before any validation and the status
produced during validation.
• F = Force ID
• S = Sensor status
logdel <group_ID>
<lastdate (YYMMDD)>
Deletes the log files that are dated earlier than the last given date.
LOGFS <ERASE|DEFRAGD|SAT> Erases all data in the log system and resets the QML data logger. Write
the command and the parameter in upper case.
loggo <group_ID> Starts logging the given log group.
Appendix A – Command Reference
141