Command Syntax Description
logshow <group_ID>
[start (YYMMDDHH)] [count]
[item_1 item_2 ...]
logshow L1 shows 1 line of the current day.
logshow L1 40 shows 40 lines of the current day.
logshow L1 170618 10 shows 10 lines starting from 18
th
June 2017.
logshownext <group_ID>
[count]
Used after the logshow command, logshownext shows the
immediately following (later) log entries.
logshowprev <group_ID>
[count]
Used after the logshow command, logshowprev shows the
immediately preceding (earlier) log entries.
logstatus <group_ID> logstatus shows the statuses of all log groups.
logstatus group_ID shows the logging state and variables of the
defined log group.
logstop <group_ID> Stops the logging of the defined log group.
md <directory> Creates a directory. For example: md /Ext/logdata
move <source_file>
[destination_file]
Copies a file to another location and removes the source file.
net <warnings|
statistics [clear]>
net statistics shows the network statistics.
net statistics clear clears the statistics.
net warnings shows the network warnings.
net warnings clear clears the warnings.
netif [open <interface>|
close <interface>]
netif shows the status of all configured network interfaces.
netif open interface opens the given interface.
netif close interface closes the given interface.
ntp <set|show|test>
<server[:port]>
[max_round_trip]
[interface]
• port specifies the port to use for the connection. The default port is
123.
• max_round_trip specifies the maximum time (in milliseconds)
allowed between requesting the server time and its reception.
• interface is the name of the interface to use for the NTP
connection.
ntp set server sets the QML data logger time.
ntp show server shows the time of the NTP server clock.
ntp test server tests the connection to the NTP server.
open
Opens a service connection.
parameters <load|save>
<filename> [‑opt ‑d|‑o|‑p]
Loads or saves static parameters and parameter sets from or to
filename. When loading static parameters and parameter sets from a
file:
• opt ‑d(efaultsonly) overwrites static parameters and
parameter sets with a default value.
• opt ‑o(verwrite) overwrites static parameters and parameter
sets.
• opt ‑p(reserve) preserves static parameters and parameter sets.
AWS310-SITE Configuration and Maintenance Manual M211828EN-C
142
To Next Page
Loading...
