HP10E / HP12E / HP15E / HP20E - Dairy design 1. Safety instructions
1-3© VEMAG 2013
1.4 General safety instructions
• Any person working on or with the machine must have read and un-
derstood these operating instructions, in particular the safety instruc-
tions.
• The machine may be used only by trained and authorised staff.
• Responsibilities during operation must be clearly assigned and obser-
ved.
• The machine may only be serviced by trained staff authorized to do
so.
• The machine may only be used if it is in perfect working order. In the
event of changes, such as loss of oil or unusual noises starting, the
machine should be stopped immediately and your in-house mainte-
nance department or VEMAG Customer Service informed.
• The machine may not be operated without the housing cover.
• Route mains cables and data cables (e.g. remote control cable) so as
to avoid tripping hazards.
• Sockets which are not being used must be rmly sealed with the
appropriate protective cap to prevent the penetration of moisture.
Corrosion at the contacts can lead to switching errors.
• It is prohibited to remove, switch off or override safety devices. In the
event of damage to safety devices, inform VEMAG Customer Service
immediately.
• Warning signs on the machine may not be removed or painted over.
• Conversions, attachments and other modications to the machine not
approved by VEMAG are not permitted.
• In all cases, generally-applicable and in-house safety and accident
prevention regulations apply in addition to these safety instructions.
To Next Page
Loading...
