VEMAG HP12E - 1.5 Special safety instructions

HP10E / HP12E / HP15E / HP20E - Dairy design1. Safety instructions
1-4 © VEMAG 2013
1.5 Special safety instructions
Danger!
To prevent injury, switch off the machine before any work (assembly, dis-
mantling, cleaning, maintenance, repair). Then switch off the main switch
to disconnect the machine from the mains.
Danger!
To prevent injury in the area of the double screws, switch off the machine
before undoing the locking nut. Then switch off the main switch to dis-
connect the machine from the mains. The lling horn holder may only be
tted or removed with the machine switched off.
Before starting up the machine, always perform the following steps:
• Check that the machine is in proper condition. Leaking oil indicates
leaks which must be eliminated immediately. In this case, inform your
in-house maintenance department or VEMAG Customer Service
immediately.
• Check that the safety devices on the hopper and lling horn holder are
working properly.
Section 5
If you notice any damage, inform VEMAG Customer Service immedi-
ately.
Danger!
To prevent injury, switch off the machine before doing any work on the
hopper. Then switch off the main switch to disconnect the machine from
the mains. Do not climb onto the machine to check the hopper/hopper
contents, use only the step provided. Under no circumstances use a lad-
der or other aid to get at the hopper of the machine.