HP10E / HP12E / HP15E / HP20E - Dairy design7. Cleaning
7-12 © VEMAG 2013
7.4 Cleaning schedule
7.4.1 General recommendations
All information relates to single-shift operation.
• Predominant use should be made of alkaline foam cleaning agents.
• To remove mineral deposits such as limescale, use acid foam cleaning
agents as required (usually 1x a week).
7.4.2 Chlorine-free alkaline cleaning agents
Perform cleaning as follows:
• Initial rinse with water to remove coarse dirt
• Application of foam to the surfaces for cleaning using a 2 – 5 % soluti-
on of P3-topax 19 (alkaline) or 2 – 3 % solution of P3-topax 56 (acid).
Time required to take effect: 10 to 20 minutes
• Intermediate rinse with water at 40 – 60 ˚C
• Disinfect if desired and/or required
• Rinse off with water at 40 – 60 ˚C
Warning!
Use chlorine-free alkaline cleaning agents if at all possible, as there is
less risk of corrosion in the event of inadequate rinsing off.
To Next Page
Loading...
