VEMAG HP12E - Fitting the Scraper

HP10E / HP12E / HP15E / HP20E - Dairy design4. Setting up
4-6 © VEMAG 2013
4.6 Fitting the scraper
A scraper can be tted to the hopper for product which sticks to the wall
of the hopper.
Danger!
There is a risk of crushing when tting and removing the scraper. To
prevent injury, proceed extremely carefully when tting and dismantling
the part.
• Inspect the scraper for residual product prior to asembly.
• Put the scraper (1) on the locking pin (2) of the feed screw and make
sure it engages.
1 Scraper
2 Locking pin
Fig. 4-6
Fitting the scraper
1
2