VEMAG HP12E - 7.2.2 Double screws; 7.2.3 Double screw housing

HP10E / HP12E / HP15E / HP20E - Dairy design7. Cleaning
7-2 © VEMAG 2013
7.2.2 Double screws
• Once the lling horn holder is removed, the double screws can be
removed by pulling them out horizontally, holding the screws steady
with the other hand.
Fig. 7-2
Removing the double
screws
• Each screw can be washed either manually, in a cleaning tank or a
dishwasher.
• After cleaning, the double screws should be inspected for any residual
product. Following this, it may be sanitized manually or mechanically
with an EPA accepted sanitizing agent.
7.2.3 Double screw housing
• Pull the double screw housing right out of the feed cylinder by hand,
holding the housing steady with the other hand.
• If the double screw housing cannot be pulled out by hand, push the
extraction device (1) into housing (2).
1 Extraction device
2 Double screw housing
Fig. 7-3
Inserting the extraction
device
1
2