VEMAG HP12E - 5. Operation; 5.1 Working with the machine

HP10E / HP12E / HP15E / HP20E - Dairy design 5. Operation
5-1© VEMAG 2013
5. Operation
5.1 Working with the machine
To start production with the machine, proceed as follows:
• Set up the machine for the product to be lled.
Section 4
• Switch on the main switch of the machine.
• Press the ON switch on the machine control panel.
Danger!
You must check that any safety devices are working properly.
• Unlock the hopper and tip it open.
• Remove the lling horn holder.
In each of the cases described, the machine must switch off automati-
cally. If the machine does not switch off, work may not continue with the
machine. In this case, inform VEMAG Customer Service immediately.
• Pull on a casing suitable for the product to be lled.