VEMAG HP12E - 6.3 Keypad

HP10E / HP12E / HP15E / HP20E - Dairy design 6. Graphical control
6-7© VEMAG 2013
6.3 Keypad
6.3.1 Numerical keypad
Numerical values are entered using the numerical keypad. Every value
entered must be conrmed with Enter.
6.3.2 Key C (Cancel)
Key C (Cancel) performs the following functions:
• back to main screen
• cancel input and exit
• exit window and menus without input
6.3.3 Screen up/down keys
Use the two arrow keys to switch pages and scroll through elds and
lists. A scroll bar is shown when you scroll.
Menu items followed by ".." show that more pages follow.
6.3.4 Padlock key
The padlock key performs the following functions:
• Open program locking/ userkey
You can use program locking to block entry for almost all parameters.
You can use the userkey to block/release access to Service functions.
6.3.5 Plus/minus keys
• Use the plus/minus keys to increase or reduce values by 1.
• You can also use the minus key to put the symbol in front
of negative input.
Enter the value in question before putting in the symbol
(e.g.: "5" rst, and then "-" to set clip offset).
6.3.6 Cursor keys
The arrow keys in the cursor eld are used to move the cursor around the
screen. The marking for an active eld indicates the position of the cursor.
You can also use the cursor keys to navigate around menus.
6.3.7 Enter key
The Enter key is used to conrm all input.