The rear panel of the monitoring unit has four indicators as shown in Monitoring Unit Rear Panel on page14 . The following
table provides descriptions for the rear panel indicators.
Silk Screen Printing Color Status Description
Power 1 Green
On Power supply 1 is on
Off Power supply 1 is off
Power 2 Green
On Power supply 2 is on
Off Power supply 2 is off
Link Green
On Correct connection
Off Wrong connection or disconnected
Speed Yellow
On 1000 Mbps rate
Off No rate
Table 2.18 Monitoring Unit Rear Panel Indicator Description
Reset button
To reset the monitoring unit:
1. Press and hold the reset button (Silk Screen Printing is “Reset”) for more than 4 seconds.
2. After the device beeps and the alarm light turns off, the monitoring unit has been reset with the IP address and
password set to factory default values. For more information, see Table 2.19 below .
USB port
The monitoring unit provides four ports of USB-A socket type. The ports can be connected to the USB modem of the
specified model, as well as the keyboard and mouse.
Ethernet port
The monitoring unit provides two network ports and one fiber port. The 10/100/1000M Ethernet port is used. For reference,
please see Monitoring Unit Rear Panel on page14 for a visual of the 1000M fiber port. The following table lists the default
network port specifications.
Parameter / NetworkCard Number IP Address Subnet Code Default Gateway
Ethernet card1 (eth0) 192.168.0.254 255.255.255.0 192.168.0.1
Ethernet card 2 (eth1) 192.168.1.254 255.255.255.0 192.168.0.1
Optic fiber port 192.168.2.254 255.255.255.0 192.168.0.1
Table 2.19 Default Network Port Specifications
NOTE: The default web browser credentials are admin/Vertiv.
DP port
The monitoring unit provides two DP ports as shown in Monitoring Unit Rear Panel on page14 .
NOTE: The reserved DP2 port is not recommended.
16 Proprietary and Confidential ©2024 Vertiv Group Corp. 2 Getting Started
Vertiv™ SmartRow™ 2 Infrastructure Solution User Guide
To Next Page